Table of Contents
Advertisement
4-5. MAIN COVER REPLACEMENT
4-5·1. Removal
a. Remove the screw (82.6 x 5) which fastens the
main cover from the chassis ass'y, and then remove
the main cover. (Refer to Fig. 4-5 )
4-5·2. Installation
a. Install the main cover so that the position marked
is set in accordance with the arrow, and then
install the main cover with the screw (82.6 x 5).
(Refer to Fig. 4-5)
Fig.
4-5
Main Cover Replacement
ED
4-6. PAD ASS'V REPLACEMENT
4.0-1. Removal
a. Remove the main cover. (Refer to 4-5)
b. Lifting the pad arm tip so that any excessive force
may not be applied to the pad arm ass'y. remove
the pad ass'y by pressing its rear part. (Refer to
Fig. 4-6 (a»
4.0-2. Installation and Adjustment
a. Pick up pad holder (not pad itselO of pad ass'y
lightly and insert pad ass'y into the location on
pad arm ass'y. (Refer to Fig. 4-6 (a) )
b. Pull down the pad arm ass'y, and check if the pad
is arranged in parallel with the head as shown
in
Fig. 4-6 (b).
-31-
Main Cover Replacement
c. Perform the pad pressure adjustment. (Refer to
5-2)
d. Perform the head clearance adjustment.
(Refer
to 5-10)
e. Perform the HL arm height adjustment. (Refer to
5~)
.
f. Make the head clean. (Refer to 5-11)
g. Perform the head compliance adjustment. (Refer
to 5-3)
h. Install the main cover. (Refer to 4-5)
Pad Arm Ass'y
Pad Holder
P~~~
Pad Ass'y
ra)
Fig.
4-6
Pad Ass'y Replacement
E12I
4-7. DAMPER REPLACEMENT
4·7-1. Removal
a. Remove the main cover. (Refer to 4-5)
b. Manually set the machine into the Disk-In mode.
(Refer to Fig. 4-9 (a) )
c. Remove the screw (PS2.6 x 6) which fastens the
damper to the head load ass'y. and then remove
the damper. (Refer to Fig. 4-7)
Advertisement
Table of Contents
