Table of Contents
Advertisement
Changing Monitor
Resolution
You can switch the resolution of the VGA output using the following
procedures.
● Press and hold the [FUNCTION] button, and press the [14/
ZOOM OUT](ZOOM OUT/CANCEL) button at the same time.
BPressing the button each time increases the resolution value.
● Press and hold the [FUNCTION] button, and press the [15/
ZOOM IN](ZOOM IN/ENTER) button at the same time.
BPressing the button each time decreases the resolution value.
Preset
: 1024 x 768 (Default value)
Values
1280 x 768
1280 x 1024
1600 x 1200
WARNING
LIVE/BROWSE
OPERATE
ALARM
HDD
SELECT
LOCK
REC CONTROL
PTZ/PRESET
FUNCTION
SERIAL
CANCEL
ZOOM OUT
ZOOM IN
ENTER
[14/ZOOM OUT]
[FUNCTION] Button
Button
[15/ZOOM IN] Button
[ZOOM OUT/
[FUNCTION] Button
CANCEL] Button
[ZOOM IN/ENTER] Button
Memo :
● Selecting a resolution not supported by the monitor may prevent
normal monitor synchronization.
Precautions when
Changing Settings
Note that any incorrect changes made to the settings of this unit
may cause it to malfunction.
● Before making any changes, save the current settings to [Flash
Memory Utility] (A Page 111) to allow you to restore the
previous settings should anything go wrong.
● It is recommended that you save the setting data before making
any changes.
● The section at the bottom left of NVR Viewer might not be
operative depending on the monitor resolution. In such a case,
double-click the bar of the currently opened upper section to
close it to enable the operation of the lower section.
VR-N1600U/E
REV
SEARCH
KEY
ALARM CLEAR
REC/STOP
STOP(PB)
PLAY
VR-N900U
Precautions when
Changing Display Settings
The following table illustrates the relation between the number of
camera channels that are displayed simultaneously and the
selectable frame rate. When creating the view to display on screen,
be careful not to exceed the respective values as shown in the table.
Basic
performance
Recording/
Display/
Distribution ips
Addition of
camera license
Live viewing
Playback of
FWD
recorded
images
SKIP
Master-Slave
connection
Live viewing
on the NVR
unit during
Master-Slave
connection
Playback of
recorded
images on the
NVR unit
during
Master-Slave
connection
Live viewing
on the
surveillance
computer
Playback of
recorded
images on the
surveillance
computer
Note :
● While the basic display performance of the VR-N1600U/E(A) is
160 ips, during the playback of recorded images, the display
performance is constrained by the above values depending on
the number of camera channels that are displayed
simultaneously on the NVR unit.
● When playing back recorded images simultaneously on the NVR
unit and surveillance computer, set the number of camera
channels that are displayed simultaneously on the NVR unit and
surveillance computer and the total frame rate such that they do
not exceed the recorded images playback performance of each
NVR.
VR-N900U/(A)/(B) VR-N1600U/E VR-N1600U/E(A)
120/60/30
160/80/80
Inapplicable
Inapplicable
1 to 9 ch: 60 ips
1 to 16 ch:
and below
80 ips and
below
1 to 16 ch:
1 to 9 ch: 60 ips
80 ips and
and below
below
Applicable
Applicable
1 to 16 ch:
1 to 9 ch: 60 ips
80 ips and
and below
below
1 to 16 ch:
1 to 9 ch: 60 ips
80 ips and
and below
below
Depends on the
Depends on
basic
the basic
distribution
distribution
performance of
performance
each NVR
of each NVR
Depends on the
Depends on
basic
the basic
distribution
distribution
performance of
performance
each NVR
of each NVR
160/160/160
Applicable
1 to 32 ch:
160 ips and
below
1 to 12 ch:
160 ips and
below
13 to 16 ch:
80 ips and below
17 to 32 ch:
Inapplicable
Applicable
1 to 32 ch:
160 ips and
below
When the
number of
camera channels
registered to the
NVR unit among
displaying
cameras is
1 to 12 ch:
160 ips and
below
13 to 16 ch:
80 ips and below
17 to 32 ch:
Inapplicable
Depends on the
basic distribution
performance of
each NVR
Depends on the
recorded images
playback
performance of
each NVR
29
Advertisement
Table of Contents
