Toshiba e-studio 281c Operator's Manual page 303

Releasing a paper misfeed in the Finisher and the Hole Punch Unit
(optional: MJ-1024/1023, MJ-6004)
1
Hold up the guide and remove any mis-
fed paper in the paper exit area.
• When the Hole Punch Unit (optional: MJ-6004) is installed, pro-
ceed to step 2. If not installed, proceed to step 6.
2
Open the front cover of the Hole Punch
Unit.
3
Turn the green knob to locate the triangle
mark within the area indicated on the
label.
• Under this condition, the punchers are up.
4
Raise the Hole Punch Unit, and remove
any misfed paper.
9
301