Toshiba e-studio 281c Operator's Manual page 26

1.Description of Each Component (Cont.)
8. Saddle Stitch Finisher (MJ-1024)
1
This finisher enables saddle stitching, in addition to sort/group finishing and stapling. The Hole Punch
Unit (optional, MJ-6004) can be installed to this finisher. The Bridge Unit (optional, KN-3511A) is
required for the installation of this finisher.
9. Multi Position Staple Finisher (MJ-1023)
This finisher enables sort/group finishing and stapling. The Hole Punch Unit (optional, MJ-6004) can
be installed to this finisher. The Bridge Unit (optional, KN-3511A) is required for the installation of this
finisher.
10. Hanging Finisher (MJ-1022) (for e-STUDIO281c/351c only)
This finisher enables sort/group finishing and stapling. The Bridge Unit (optional, KN-3511A) is
required for the installation of this finisher.
11. Hole Punch Unit (MJ-6101)
This unit enables you to punch holes on printouts. It can be used by installing it on the Finisher
(MJ-1101).
12. Hole Punch Unit (MJ-6004)
This unit enables you to punch holes on printouts. It can be used by installing it to the Saddle Stitch
Finisher (MJ-1024) and Multi Position Staple Finisher (MJ-1023).
Other options available are as follows. Contact your service technician or Toshiba product distributors for
details.
Work Table (KK-3511)
This is a small table for placing originals while the equipment is operated.
• Cannot be installed with e-BRIDGE ID Gate at the same time
FAX Unit (GD-1200)
This is a unit for using the equipment as a Fax.
2nd Line for Fax Unit (GD-1160)
This unit enables to add a line to the Fax to make it 2nd line.
• The Fax Unit (GD-1200) is necessary.
Desk (MH-1700)
This is a desk for the equipment.
Data Overwrite Kit (GP-1060)
This is a kit to erase the data stored temporarily when copying, printing, scanning, Fax, internet Fax or net-
work Fax is performed. It overwrites temporarily stored data with random data.
Scrambler Board (GP-1040)
This board enhances the security of the equipment. Data are encrypted when they are written into the hard
disk of the equipment and decrypted when they are read.
Parallel Board (GF-1140)
This kit is used when the equipment is connected in parallel with a computer.
• The PCI slot (GO-1060) is necessary.
24
1.BEFORE USING EQUIPMENT