JVC RX-D402B Service Manual page 18

3.2 Front panel assembly section
• Remove the front panel assembly.
(See "3.1.3 Removing the front panel assembly".)
3.2.1 Removing the JOG board
(See Figs. 1 and 2)
(1) From the inside of the front panel assembly, remove the
four screws A attaching the JOG board. (See Fig.1.)
(2) Take out the JOG board while lifting it from the front panel
assembly little by little.
Reference:
The MASTER VOLUME knob and SOURCE SELEC-
TOR knob are removed from the front side simulta-
neously. (See Fig.2.)
(3) From the forward side of the JOG board, disconnect the
wire from the connector CN913. (See Fig.1)
3.2.2 Removing the OSD connect 2 board
(See Fig. 1)
(1) From the inside of the front panel assembly, remove the
two screws A attaching the OSD connect 2 board.
(2) Disconnect the wire from the connector
board.
3.2.3 Removing the FL board
(See Fig. 3)
• Remove the JOG board.
(1) Remove the eight screws A and take out the FL board.
(2) Disconnect the wire from the connector
board.
1-18 (No.MB448)
CN914 on the FL
Front panel assembly
CN914 on the FL
Front panel assembly
CN913
A
A
A
JOG board
OSD connect 2 board
Fig.1
SOURCE SELECTOR knob
Fig.2
Front panel assembly
A
A
Fig.3
CN914
FL board
A
MASTER VOLUME knob
FL board
A
A
CN914