Installer Setup - Honeywell T7200D Product Data

T7200D,E, T7300D,E,F AND Q7300 SERIES 2000 PROGRAMMABLE COMMERCIAL THERMOSTATS AND SUBBASES
ENTER OCCUPIED
PROGRAM MODE
RETURNS TO
NORMAL
OPERATIONS
SET OVERRIDE Temporary
TEMPERATURE
OFFSET AND
ACTIVATE
Continuous
TEMPORARY
Unoccupied
OVERRIDE
ENTER HOLD MODE
Table 7. Default Temperature Setpoints.
Control Occupied
Heating 70°F (20°C)
Cooling 78°F (25.5°C)

INSTALLER SETUP

NOTE: For most applications, the thermostat factory
settings do not need to be changed. Review the
factory settings in Table 8 and if no changes are
necessary, go to the Installer System Test section.
The Installer Setup is used by the installer to customize the
thermostat to specific systems. Installer Setups are listed in
Table 8. The table includes all the configuration options
available.
A combination of key presses are required to use the Installer
Setup feature.
— To enter the Installer Setup, press and hold the Heat/Cool
Settings key and both the increase
keys until the first number is displayed. All display
segments appear for approximately three seconds before
the number is displayed. See Fig. 12 and 13.
63-4355—2
ENTER UNOCCUPIED
PROGRAM MODE
SET CURRENT DAY OR
PROGRAM DAY
Mon
Occupied
System
Heat
Set Program
Run Occupied Unoccupied
Program Start Time Start Time
Set Current Clear
Occupied Day/Time Start Time
SET CURRENT
DAY AND TIME
CLEAR PROGRAM PERIOD
Fig. 11. Thermostat key locations and descriptions.
Unoccupied
55°F (13°C)
90°F (32°C)
and decrease
SET OCCUPIED
TEMPERATURE
SETPOINTS
AM
Room
Fan
Auto
Set Temperature
Occupied Unoccupied
Day Temp Temp
Heat/Cool
Copy Settings
System Fan
SELECT
SELECT FAN
SYSTEM
OPERATION
OPERATION
COPY ONE
PROGRAMMED DAY
TO ANOTHER DAY
Set Program Start Time
Em Ht
Aux Ht
Comm
Mon TueWedThuFriSatSun
Un Occupied 12 Override
System
Em Heat Off Cool
Fig. 12. LED display of all segments.
MODE NUMBER
DISPLAY
(COLUMN 2
OF TABLE 8)
Fig. 13. Installer Setup number and setting display.
10
SET UNOCCUPIED TEMPERATURE
SETPOINTS AND SCROLLS
THROUGH INSTALLER SETUP
AND SYSTEM TEST
INCREASE
TEMPERATURE
Change
OR TIME SETTING
Time/Temp
DECREASE
TEMPERATURE
OR TIME SETTING
CHANGE BETWEEN HEATING
AND COOLING SETPOINTS
AND SCROLLS BACKWARDS
THROUGH INSTALLER SETUP
NUMBERS AND SYSTEM TEST
Temporary Setting Enrg
Set Day/Time
AM
PM
Heat Cool
In Recovery Auto Only
Lo Med Hi Fan
Auto Wait
FACTORY SETTING
OR OTHER CHOICE
DISPLAY (COLUMN 3
OR 5 OF TABLE 8)
M10233A
Sav
Room
%Humid
Remote
Duct
On Auto
M4916
M10227