Description Of Each Component - Toshiba E-Studio 205L Quick Start Manual

Chapter 1 PREPARATIONS

Description of Each Component

This section describes the names and operations of the components and options.
Front / Right side
1.
Reversing Automatic Document Feeder
(optional, MR-3021/MR-3022)
The stack of originals is scanned one sheet at a time. Both
sides of the originals can be scanned. A maximum of 00
sheets (80 g/m
(The maximum number of sheets that can be set may vary
depending on the media type of the originals.)
2.
Operator's Manual Pocket (back, optional,
KK-1660)
Keep the manual in this pocket.
3.
Automatic duplexing unit
This unit makes copies on both sides of the paper. Open it
when paper jams occur.
4.
Bypass tray
Use this to perform printing on special media types such
as OHP film, etc.
5.
Paper holding lever
Use this to locate paper on the bypass tray.
6.
Paper feed cover
Open this cover when releasing paper misfed in the
drawer feeding area.
2
11
10
9
or 20 lb. Bond) can be placed in one go.
2
1
2
3
4
5
6
7
8
7.
Paper feed cover (optional)
Open this cover when releasing paper misfed in the Paper
Feed Pedestal (optional) or Large Capacity Feeder (optional).
8.
Paper size indicator
9.
Paper Feed Pedestal (optional, KD-1025) and
Additional Drawer Module (optional, MY-1033)
or Large Capacity Feeder (optional, KD-1026)
10.
Drawer
A maximum of 550 sheets (80 g/m
sheets (05 g/m
placed in one go.
11.
Front cover
Open this cover when you replace the toner cartridge and
clean the charger.
12.
USB terminal (4-pin)
Use this terminal when connecting this equipment to a PC
with a commercially available USB cable.
13.
Network interface connector
Use this connector when connecting this equipment to a
network.
12
13
or 20 lb. Bond) or 50
2
or 28 lb. Bond) of plain paper can be
2