Prints Of Tags With Automatic Feeder In "Stack" Feeder; Mode; Feeder Accessories; Preparing Of The Card Store - ABB HTP500 User Manual

4 – PRINTS OF TAGS WITH AUTOMATIC FEEDER IN "STACK" Feeder

Mode

This shows how to print Automatically the cable tags with HTP500 V2 easily and quickly.
All you need to do is to mount correctly the Feeder on the printer's guides and utilize the right
Plate following carefully the instructions here below.
4.a Feeder accessories
4.b Preparing of the Card Store
4.c Preparing of the Support Plate and card Store
4.d Turning on the Printer
4.e Print on cable tags

4.1 FEEDER ACCESSORIES

HTP500 V2 is supplied with the following accessories:
HTP500-FEED – Card Store

4.2 PREPARING OF THE CARD STORE

Position the HTP500 V2 in an operative system in where all the Safety Information are
observed.
Execute all the described operations with the printer turned off.
Position the HTP500 V2 on its proper support base as in the picture.
HTP500-PL Support Plate for Cable Tags
Mobile support
for loading the
Items
Screw A
Locking card Store