Removing A Plate - ABB HTP500 User Manual

2) Press the (I) side of the power switch to turn on the printer. The power led on the control
panel lights.
3) After the printer performance of its internal tests, if no irregularities are detected, the online
led lights and the printer is ready to print. If any item is loaded into the printer, the printer will
detect the leading edge of the article.
The following messages appear:
PLEASE WAIT...
VERSION X.X
PRINT READY..
PLATE SBLACK
2.6.2 Turning the Power Off
1) Ensure that the printer is not performing any operation.
2) Press the (0) side of the power switch to turn off the printer.
Do not ever turn off the printer while it is printing so to avoid any possible damages on the
printer head or ribbon cassette.
To cancel the printing and the related printing data, keep pressed the CANCEL Key for at
least 3 seconds. At the prints end the item will be ejected.
The printing on an Item has an external margin (top, bottom, right, left) of 2 mm.
The guaranteed printed Area has a maximum height of 54mm and a maximum length of
496mm.
The guaranteed printed area is centred in height between the top and bottom margin

2.7 REMOVING A PLATE

Press CANCEL on the control panel to remove a plate or sheet already loaded into the
printer. The roller will lift up allowing you to remove the item.
After the printing process, a plate is Automatically ejected.
Use the Remove function in case a plate should not be ejected after printing.
Automatic ejection after 5 Minutes
If a plate has been left loaded in the printer for 5 minutes straight without pressing any key
or without receiving any data input from the PC, the roller will lift Automatically up, allowing
the plate to be removed.
NOTICE
REMIND
REMIND
REMIND