Attaching/Detaching The Stand And Wall Mounting - Technika 19-248COMI Manual

Attaching / Detaching the stand and wall mounting
ATTACHING/DETACHING THE STAND
b
For the assembly you will need a screwdriver.
Place TV body on flat surface panel facing downwards to avoid damage to the panel.
Attach the stand neck (b) to the body of TV unit (a) with 4 screws (c).
1.
Insert the TV into the stand at 45 degrees (d).
2.
Twist the TV into the CLOSE position until it clicks into place (e).
3.
Please follow the instructions described in the instructions for safe placing your TV!
Detaching the Stand
1) To remove the base, press close button and rotate 45 degrees.
2) Remove the 4 screws highlighted
IMPORTANT - Before drilling any holes in the wall ensure you are not drilling
where there could be any electric wires, water or gas pipes.
Wall mounting the TV
This television requires a VESA 100 wall mount, or equivalent.
1) Remove the four screws highlighted below.
2) The wall mount can now be easily attached to the mounting holes on the rear of the TV. These holes
are indicated in the picture below.
Important – If wall mounting this TV, only
use the screws already provided in the wall
mounting holes. Using other screws which
are longer could cause irreparable damage to
internal parts.
Manual - Technika 19-248 COM, 22-248COM, 24-E242COM ROI.indd Sec1:9 Manual - Technika 19-248 COM, 22-248COM, 24-E242COM ROI.indd Sec1:9
a
c, 4 x M4x10 (M4x8)
For optimum viewing,
if wall mounting the TV
higher than eye level,
the TV should be tilted
downwards so that the
TV's screen is 'face on'.
See fi g 1 and 2
45°
90°
d
45°
fi g 1
INCORRECT
CORRECT
fi g 2
e
PUSH
TV
Viewing angle
TV
Viewing angle
01/08/2012 17:10:25 01/08/2012 17:10:25
9 9