Detaching The Stand And Wall Mounting - Technika 40-260 User Manual

Attaching/Detaching the stand and wall mounting
ATTACHING/DETACHING THE STAND
Attaching the Stand
Insert the four screws into the base of the stand
Detaching the Stand
1) Remove the 7 screws highlighted.
2) You should now be able to detach the stand.
IMPORTANT - Before drilling any holes in the wall ensure you are not drilling
where there could be any electric wires, water or gas pipes.
Wall mounting the TV
1) Firstly detach the stand as shown above then remove the four screws highlighted below.
2) The wall mount can now be easily attached to the mounting holes on the rear of the TV. These holes
are indicated in the picture below.
Important – If wall mounting this TV, only use the screws already provided in the wall mounting holes.
Using other screws which are longer could cause irreparable damage to internal parts.
IMPORTANT NOTE. Occasionally we may release new software/firmware
upgrades/enhancements for this television. Please check the 'firmware
Technika 40 LED.indd Sec1:9 Technika 40 LED.indd Sec1:9
upgrade' section of the website regularly.
9 9
25/02/2010 17:37:40 25/02/2010 17:37:40