Table of Contents
Advertisement
4. Installation Instructions
How to Install Your Alarm
Direct Plug Alarm To install:
1. Choose a standard 120V unswitched outlet to
plug the alarm into.
2. Write the date ten years from installation on
the Replace by sticker
on the CO alarm.
3. If outlet is mounted
sideways, (horizontal)
rotate the AC blades.
4. If desired, activate the
tamper resist switch by
moving the tamper
resist disable slide to the "ON" position. The tamper resist feature
signals a loud 85dB alarm should the unit become unplugged or
loose from the outlet. (See Tamper Resist Feature details in the
Product Features and Specifications section.)
5. Pull the yellow tab to activate the battery backup.
6. Plug the alarm into the outlet.
Important Labels Provided
Two labels have been provided that have important information on what to
do in case of an alarm. Add the phone number of your emergency service
provider in the space provided. Place one label next to the alarm after it is
mounted, and one label near a fresh air source such as a door or window.
5. Alarm Characteristics
Carbon Monoxide Alarm Indicator
When the alarm senses a dangerous level of CO, the unit will emit a
loud alarm pattern. The alarm pattern is 4 quick beeps followed by 5
seconds of silence. This cycle repeats as long as a dangerous CO
conditions exist. The red Alarm LED will flash the same pattern.
WARNING: This model will stay in alarm on battery operation as
!
long as dangerous CO condition exists
6.Operating Characteristics
When you first power up the alarm: The alarm will sound briefly,
then the green Operate LED will light. This indicates that the CO alarm is
receiving power and that the alarm circuit is functioning.
Within a few minutes, your carbon monoxide alarm will start monitoring
for CO and will continue to do so as long as it receives power or the end
of life function is activated.
Tamper-Resist
Activate Slide
90º ROTATING DIRECT
PLUG
Tamper-Resist
Activation Switch
Hide quick links:
Advertisement
Table of Contents
