Table of Contents
Advertisement
4. Installation Instructions
How to Install Your Alarm
Direct Plug Alarm
To install:
1. Remove the switch cover.
2. Choose a standard 120V unswitched outlet to
plug the alarm into.
3. If outlet is mounted sideways (horizontally), rotate
the plug and plug the alarm in.
Note: This model is equipped with a feature that automatically activates
the battery backup when the alarm is plugged into an AC outlet for the
first time.
CAUTION: Do not rotate the alarm while it is plugged into an
!
outlet, as damage to plug may result.
Important Labels Provided
Two labels have been provided that have important information on what to
do in case of an alarm. Add the phone number of your emergency service
provider in the space provided. Place one label next to the alarm after it is
mounted, and one label near a fresh air source such as a door or window.
5. Alarm Characteristics
Carbon Monoxide Alarm Indicator
When the alarm senses a dangerous level of CO, the unit will emit a
loud alarm pattern. The alarm pattern is 4 quick beeps followed by 5
seconds of silence. This cycle repeats as long as a dangerous CO
conditions exist. The red Alarm LED will flash the same pattern and the
PPM will be displayed on the digital display.
The digital display will be brightly lit if the unit is in alarm.
WARNING: If at any time you test the alarm and it does not
perform as described, have it replaced immediately.
6. Operating Characteristics
When you first power up the alarm: The red Alarm LED will light and
the alarm will chirp once.
CO alarm power indicators:
AC - Digital display constantly on.
DC Only - Green LED flashes briefly once every 60 seconds.
Within a few minutes, your carbon monoxide alarm will start monitoring for
CO and will continue to do so as long as it receives power.
Whenever the KN-COP-DP-10YL is operating, the digital display will display
"0"(with AC applied) to indicate the unit is monitoring for CO.
90º ROTATING DIRECT
PLUG
Hide quick links:
Advertisement
Table of Contents
