Samsung ViasatHD DSB-H670N User Manual page 187

3. Using the TV code table
If, after performing a code search, your remote control still does not operate your television,
you may be using the wrong code. Try repeating the search again to locate the correct code.
If this fails, you can use the TV code table available for download from the Viasat website.
1. Download the TV code table from the Viasat website (www.viasat.se), find the brand of your
television in the TV code table and select the first 4-digit code in the list.
2. Make sure your television is fully on (not in standby), and then press the TV button on your
remote control and release it.
3. Press and hold down the SETUP key, until the red LED under the TV button blinks twice.
4. Use the numeric (0-9) key to enter the 4-digit code for your television (the TV button will blink
twice after you have entered the fourth digit).
5. Press the
If your television does not respond, repeat steps 1 to 5 with each code listed for your brand.
If none of the codes operate you television, or if your brand is not listed, the code search
described on page 30.
6. Switch your television back on by pressing the numeric (0-9) or CH+ key and check if all the
function are working properly.
7. For future reference, write down the code in the space provide in the remote control battery
compartment.
4. Resetting your remote control
To clear all the settings you have made to your remote control and apply the factory defaults:
1. Press and hold down the SETUP key, until the red LED under the TV key blinks twice.
2. Use the numeric (0-9) key to enter 981. The red LED under the TV key blinks twice.
The factory default values are applied to your remote control.
T T E E L L L L I I T T E E R R E E C C
SETTING UP THE REMOTE CONTROL
key to see if you are able to switch off your television.
E E I I V V E E R R
FOR YOUR TV
31