5.3.2 LNB Setup
This function sets the LNB manually. This function sets
the LNB manually. Default values are already entered
on this screen. Normally you do not need to change
these. If you change your satellite dish installation, you
may need to change the values.
Press the
●
Press the
●
of LNBs".
Enter Low Band and High Band frequency using the numeric (0-9) key.
●
RED key: Return to the settings menu.
BLUE key: Apply changes.
Note
Note
: If more than one receiver are to be connected to the same SATCR LNB, already installed
receiver/s has to be disconnected from the wall socket. When the new receiver has been
installed, previously disconnected receivers can then be powered up again.
5.3.3 Scart Setup
This function sets the Scart output of your receiver.
Press the
●
Press the
●
TV Scart Output: "RGB", "Composite" and
"S-VIDEO".
AUX Scart Output: "Composite".
RED key: Return to the settings menu.
BLUE key: Apply changes.
Note
Note
: "AUX Scart Output" does not support RGB.
5.3.4 Resolution Setup
This function sets the resolution for the HDMI output.
Press the
●
RED key: Return to the settings menu.
BLUE key: Apply changes.
T
E
L
L
I
T
E
R
E
C
/
key to select setup items.
/
key to select "LNB type" and "Number
/
key to select setup items.
/
key to select Scart output type.
/
to select 720p or 1080i.
E
I
V
E
R
OPERATING THE RECEIVER
27