Cornelius 500 Series Installation Manual page 9

Continuous flow icemaker

Hide thumbs Also See for 500 Series:

Table of Contents

Evaporator

3. Carefully rotate the extruder head until the tabs on the extruder head drop into the slots on the evaporator

plate, as shown in Figure 3. When the auger/extruder head assembly is rotated to the proper position, it will

drop about 1/4 inch to more fully engage the motor drive shaft.

NOTE: Not all the tabs are the same width. Therefore, you must rotate the auger until all the tabs

are properly aligned with the evaporator slots. This may require almost a complete rotation

of the extruder head to complete.

CAUTION:

Keep hands out of the way when rotating the extruder head. When the auger is aligned, it drops down quickly and a

finger may be pinched due to the weight of the auger/extruder head assembly.

Failure to lock the extruder head tabs into the evaporator slots causes the auger to be out of proper alignment with

the evaporator. This may cause excessive loads on the auger that can potentially result in excessive noise and

tripping the drive motor overload.

Continuous Flow Icemaker Installation Manual

Figure 2.

Figure 3.

- 5 -

Extruder

Head

All tabs &

slots engaged

Publication Number: 630460174INS

Table of Contents

2000 series 700 series Quantum 1000