ViewSonic VT2730-1M Service Manual page 7

2. Video
Built-in A/D converter shall provide analog to digital converter for this product.
Input Parameter
CVBS Characteristics:
Video Amplitude Signal
DC Level Sync Pulse
S-Video Characteristics:
Video Amplitude Signal
Y, Pb, Pr Characteristics:
Video Amplitude Signal
Video Bandwidth
HDMI Characteristics
RGB Characteristics:
Signal Type
Sync Type
Input Signal Rating
Sync Level:
Frequency Range
Pixel Color
DDC Compliance
EDID Data Table
3. Audio
Audio amp of this product shall be provided by "TI" with a Model Number of TPA3113D2 .
"MST" MSD3003 for VT2730-1M shall be used as sound processor. In addition, a pair of speakers shall
be integrated within this product. The audio signals of this product shall comply with the specification
listed in the following table.
Parameter
Power Output Max Rating
Speaker Impedance
Line In
Line Out earphone jack
Flatness of Amplitude
Response
Total Harmonic Distortion
(Po=0.1 to 1 W, f=1KHz)
Signal to Noise:
ViewSonic Corporation
0.7(min.) – 1.1(max.) V
Typical. 0.3 V
Y : 1.0Vp-p W / Neg. Sync (IN 75
C : 0.285Vp-p (IN 75 )
Y:1.0Vp-p (IN 75 )
Pb:0.7 Vp-p(IN 75 ),Pr:0.7 Vp-p (IN 75 )
NTSC: 6 MHz Maximum
Panel Link T.M.D.S HDMI-1.3
Analog VGA
TTL, Separate Sync, with 2.2K pull-down resistors
1250mV Max without damage to the product, 0-700 mV Full Range
2.5-5.25 V
Horizontal: 30-82K Hz, Vertical: 55-76 Hz
16.7 M
DDC2B Compliant, Rev 1.3
Refer to Appendix
Tuner Input
5W at 10 % T.H.D Distortion
main speaker :6
NTSC: BTSC Mono / Stereo(standard)
PAL: FM Mono / Stereo(standard)
+/- 3 db (at 1KHz @1W)
<2%
12 dB (100Hz to 1KHz)
8 dB (1kHz to 10kHz)
6
Specification
)
Specification
Base band Input
5W at 10% T.H.D Distortion
main speaker :6
500 mV rms (Typ)
1.6 V rms (Max)
Impedance: 600 ohms
500 mV rms
15 mW@32
+/- 3 db (at 1KHz @1W)
<2%
35 dB (100Hz to 10 kHz)
Confidential - Do Not Copy VT2730-1M