Haier HD70-A82 User Manual page 11

6 Timer buttons
7 Empty tank indicator
8 Delicate button
9 Anti-Crease button
10 Rack button
11 Cool Air button
12 Start/Pause button
13 Program knob
14 Power button
signal
Modify the default time to your needs, using the +
and - timer buttons.
Water tank must be emptied.
Important: Empty the water tank after each
drying cycle. See Empty the water tank section
of the manual.
Use this function for delicate fabrics. It lowers the
temperature and lengthens the drying cycle time
to take better care of the laundry.
Use this function to lengthen the automatic
anticrease phase at the end of each program by
60 minutes.
Note: The laundry can be removed at any time
during the anti-crease phase.
Press the Rack button if the rack should be used
in a drying cycle.
Use this function for fabrics that can not be dried
with one of the heat settings.
Press Start/Pause to Start a drying cycle. Press
button again to pause the drying cycle – indicator
light is flashing. Press button again to continue.
Select one of the 12 programs using this knob.
The indicator of the respective program lights up.
See Program Modes section of the manual for
further information.
Press Power button to switch on/off the tumble
dryer.
You can choose signal as you need. To activate
the signal function after the Cool air cycle has
been selected, press temp & delicate for 5 sec.
until the screen show beep on. To deactivate
press both button for 5 sec. again until the screen
show beep off.
English | 11