Ricoh M052 Service Manual page 551

Protocol dump list output after
each communication
6
0: Off
1: On
7 Not used
System Switch 01 - Not used (Do not change the factory settings.)
System Switch 02 [SP No. 1-101-003]
No FUNCTION
0-1 Not used
Force after transmission stall
2 0: Off
1: On
3
Not used
File retention time
0: Depends on User
4
Parameter 24 [18(H)]
1: No limit (until the year 2126)
5
Not used
SM
This is only used for communication
troubleshooting. It shows the content of the
transmitted facsimile protocol signals. Always
reset this bit to 0 after finishing testing.
If system switch 09 bit 6 is at "1", the list is only
printed if there was an error during the
communication.
Do not change the setting.
COMMENTS
Do not change these settings.
With this setting on, the machine resets itself
automatically if a transmission stalls and fails to
complete the job.
Do not change these settings.
1: A file that had a communication error will not be
erased unless the communication is successful.
Do not change this setting.
45
Bit Switches
M381