Start-Stop - Skoda Fabia Owner's Manual

WARNING
First ensure that it is not too high for the traffic conditions which exist at that
moment before resuming the stored speed.
Changing a stored speed
You can also change the speed of the vehicle without depressing the
accelerator.
Faster
– You can increase the stored speed without depressing the accelerator, by pressing
A  page 94, fig. 98
the rocker button
B
– The speed of the car will increase continuously if you hold the rocker button
pressed in the RES+ position. Once the vehicle has reached the desired speed,
release the rocker button. The set speed is then stored in the memory.
Slower
– You can decrease the stored speed by pressing the rocker button
position.
– Holding down the pushbutton pressed in the SET- position will cause the speed of
the vehicle to reduce continuously. Once the vehicle has reached the desired
speed, release the rocker button. The set speed is then stored in the memory.
– If you release the rocker button when the vehicle is travelling at a speed of less than
30 km/h, the speed is not stored, the memory is erased. It is then necessary to again
store the speed with the rocker button
speed of the vehicle to more than 30 km/hour.
Switching off the cruise control system temporarily
– You can switch off the cruise control system temporarily by depressing the brake
pedal or clutch pedal, on vehicles fitted with an automatic gearbox only with the
brake pedal.
– You can switch off temporarily the cruise control system, if you press the switch
in the middle position.
Using the system Safety
into the RES+ position.
A
in the SET-
B
A
in the position SET- after an increase in
B
Driving Tips
The set speed remains stored in the memory.
The Resumption of the stored speed is achieved by releasing the brake or clutch
pedal, on vehicles fitted with automatic gearbox only after releasing the brake pedal
and after shortly pressing the rocker button
RES+.
WARNING
First ensure that it is not too high for the traffic conditions which exist at that
moment before resuming the stored speed.
Switching off the cruise control system completely
A  page 94, fig. 98
– Press the switch
A

"START-STOP"*

The "START-STOP" system helps you to save fuel while at the same time reducing
exhaust pollutants and CO emissions.
2
The system is automatically activated each time the ignition is switched on.
The system switches the engine off automatically when the vehicle comes to a stand-
still, such as while waiting at a traffic light.
Information regarding the current state of the "START-STOP" system is indicated in the
A
A
display of the instrument cluster.
General Maintenance
Starting-off and Driving
A  page 94, fig. 98
into the position
B
to the right into position OFF.
Fig. 99 Centre console: Button for the
START-STOP system
Breakdown assistance Technical Data
95