Volume, Sound Mode And Other Controls - JVC Kaboom ! Series RV-B550BU Instructions Manual

VOLUME, SOUND MODE AND OTHER CONTROLS

VOLUME buttons
+ : Use to increase the volume.
– : Use to decrease the volume.
(Control range from VOL 0 to VOL 50.)
Main unit
VOLUME
AHB (Active Hyper Bass*) PRO button
BASS 1: The AHB PRO indicator lights up, and a mild bass boost is added to the
sound.
BASS 2: The AHB PRO indicator lights up, and a stronger bass boost is added to
the sound.
OFF : The AHB PRO indicator goes out. Set to this position when Active Hyper
Bass Pro sound is not required.
* Active Hyper Bass (AHB) Pro
The Active Hyper Bass Pro circuit reinforces the bass sound to maintain
rich, full bass at low volumes (playback only).
Main unit
AHB PRO
SPEAKER ILLUMINATION/ACS (Active Clear Sound*) button
Press this button to turn enhanced sound reproduction ON/OFF. When
on, a light in each speaker flashes.
* Active Clear Sound (ACS)
The Active Clear Sound (ACS) circuit emphasizes high-frequency sound
without lowering the signal-noise ratio, while adjusting its output according
to the input signal level. This results in a better balance between the
high-frequency sound and the low-frequency heavy bass sound.
Note:
This fuction has no effect with monaural sound sources.
Main unit
SPEAKER
ILLUMINATION
/ACS
Lights in green when the ACS is ON.
12
Remote control unit
VOLUME
Remote control unit
AHB PRO
AHB PRO
AHB PRO indicator lights in red when
AHB PRO is set to BASS 1/BASS 2.
Remote control unit
ACS
ACS
Sound mode button
Sound modes can be selected to enhance the type of music being played.
÷ Press the SOUND button to select the sound mode.
÷ Each time the SOUND button is pressed the sound mode changes as
follows:
Main unit Remote control unit
SOUND
SOUND
÷ The factory-preset is "FLAT". Each time the SOUND button is pressed, the
display changes as shown.
Sound mode selection
LIVE:
Set to this position for heavy metal or rock music.
POP:
Set to this position for light music including popular and vocal music.
CLEAR:
Set to this position for crisp and clear sounding music with transparent
highs.
FLAT (No sound effect (flat characteristics)):
Set to this position when listening to classical music.
Note:
The selected modes only affect the sound output from the speakers or
headphones. They do not affect the sound when recording.