Points To Remember When Making The Electrical Connection - GEM KMG Series Installation And Maintenance Manual

7 • POINTS TO REMEMBER WHEN MAKING THE ELECTRICAL CONNECTION
7.1 • As all ovens of the series are fitted with
an alternating fan motor (clockwise and
anticlockwise rotation), there is no need
for the fan to rotate in any particular
d i r e c t i o n . S i m p l y v e r i f y , w h e n
c o m m i s s i o n i n g t h e a p p l i a n c e , t h a t
the fan is balanced and rotates freely.
Warning: the 20 x GN 1/1 and 20 x GN 2/1
models are equipped with two motors.
7.2 • When making the electrical connection
you need to take care that the neutral
pin of the terminal block corresponds to
the neutral wire of the supply line. If this
connection is not made correctly, the
burners will not be able to operate.
7.3 • This trouble is indicated:
On gas models mechanical version by the
burner ignition reset button, which is lit up.
On gas models electronic version via the
electronic card.
7.4 • Check also that the neutral registers
zero potential when tested. If not, the
fault already described in point three of
this section will occur. In this eventuality,
consult the installer of the building's
electrical system.
11
90027360rev00