Location and Function of Parts
Front Panel
POWER A, B, C, D switches and status indicators
POWER A, B, C, D switches and status indicators
The POWER switches turn the unit on and off. The unit is
powered on when the POWER switches are on the "?" side,
and powered off when the POWER switches are on the
"a" side. The status indicators light in green when the unit
is powered on.
Depending on the configuration of your unit when
shipped, the HK-PSU05 Power Supply Unit may not be
installed. In this case, only the POWER A and POWER B
switches are available. There is no POWER C and
POWER D switches. The unit does not operate until two of
the four power switches (A, B, C and D) are on.
When the HK-PSU05 is installed, operation continues as
long as two power supplies are normal.
Notes
• When installing the HK-PSU05 in your unit, be sure to
contact your Sony service representative.
• If a status indicator does not light when you turn a
POWER switch on, there may be a fault in the power
circuits. Turn the POWER switch off and contact your
Sony service representative.
• If you cannot press the "?" side of the POWER switch to
power on, slide the red cover in the direction of the arrow
shown in the figure, then press.
Rear Panel
MVS-8000X
MVS-7000X
1Connector
panel (upper
section)
2Connector
panel (lower
section)
1Connector
panel (upper
section)
2Connector
panel (lower
section)
Location and Function of Parts
11