Pioneer AVIC-Z2/XU/UC Service Manual page 316

5
- Removing the roller ASSY (fig. 14)
1. Remove the module pc board in accordance with the procedure of "Removing the module pc board."
2. Remove the upper frame ASSY in accordance with the procedure of "Removing the upper frame ASSY."
3. Remove the tension spring.
4. Remove the load gear ASSY in accordance with the procedure of "Removing the load gear ASSY."
5. Enter the quasi-clamp mode in accordance with the procedure of "Setting the quasi-clamp mode manually."
6. Remove the disc guide ASSY in accordance with the procedure of "Removing the disc guide ASSY."
7. Remove the CRG ASSY in accordance with the steps 4 and 5 in the procedure of "Removing the CRG ASSY."
8. By pushing the fixed portion of the load lever R, move the load lever R to the rear side completely.
9. Remove the load levers R and L. Unhook the end of the roller arm spring R from the load lever R.
10. While lifting the roller ASSY to the highest position, slide it to the right side. Lightly bend the whole slot guide by
pushing the ends with your fingers and remove the roller ASSY.
Roller arm spring L
5
6
Slot guide
Tension spring
Roller ASSY
C X - 3 01 6
6
7
Move to the rear
side
Load lever R
Roller arm spring R
Push the ends to lightly bend the whole slot
7
8
A
B
C
D
Fig. 14
E
F
27
8