Reset - Yaesu VX-5R Operating Manual

Reset
MICROPROCESSOR RESETTING
Turn the radio off.
0 Press and hold the
[4(MG)DSP], [MR(SKP)SC],
and
[VFO(DW)SC]
key whil
turning the radio
on .
e
Press the
IF/W]
key momentarily
to initialize the radio.
Turn the radio off:
SET MODE RESETTING
Press and hold the
[MR(SKP)SC]
and
[VFO(DW)SC]
key while turning the
radio o
0
n.
Press the
[F/VI/]
key momentarily
to initialize the Set
mode .
VX-SR OPERATING MANUAL
,_-5R
includes a convenient "Clone" feature, which allows the memory and
configu-
,. data from one transceiver to be transferred to
another
VX-5R . This can be particu-
useful when configuring a number of transceivers
for a public service operation. Here
e procedure for Cloning one radio's data to another:
Turn both radios off.
Connect the optional CT-27 cloning cable between the
MIC/EAR
jacks of the two
radios .
Press and hold the
[FIW]
key while turning the radios on . Do this for both radios (the
order of the switch-on does not matter).
"CLONE"
will appear on the displays of both
radios when the Clone mode is successfully activated in this step .
On the Destination radio, press the
[MR(SKP)SC]
key
("CLONE
WAIT" will appear on the LCD) .
Press the
[VFO(DW)SC]
key on the Source radio;
"CLONE
TX" will appear on the Source radio, and
CLONE WAIT
the data is transferred .
If there is a problem during the cloning process,
"CLONE ERROR"
will be displayed. Check your
cable connections and battery voltage, and try again.
07 If the data transfer is successful, the Destination ra-
dio will return to normal operation; the Source radio
will still be in the clone mode, with
"CLONE
TX" still displayed.
and disconnect the CT-27. You can then turn the radios back on,
and begin
operation.
CLONE
TX
Turn both radios off
normal