Yaesu VX-5R Operating Manual page 22

Advanced Operation
ARTS Alert Beep Options
The ARTS feature allows two kinds of alert beeps
(with the additional option of
tu,
them off), so as to alert you to the current status of ARTS
operation . Depending on ,
location and the potential annoyance associated with frequent
beeps, you may choose
Beep mode which best suits your needs . The choices are :
ALL:
ARTS (AUTOMATIC RANGE TRANSPONDER SYSTEM
IN RANGE :
The beeps are issued only when the radio first confirms
that you
within range, but does not re-confirm with beeps thereafter.
Every time a polling transmission is received from
the other station,
alert beeps will be heard .
No alert beeps will be heard ; you must look at the display to con
current ARTS status .
OFF :
set the ARTS Beep mode, use the following procedure:
Press the [F[W] key, then press the [BAND(SET)AR]
key, to enter the Set mode .
Rotate the
DIAL
to select Menu # 18
("ARTS BEEP") .
Press the
[BAND(SET)AR]
key to enable changing of this Menu item .
Rotate the
DIAL
to select the desired ARTS Beep mode (see above) .
When you have made your selection, press the PTT key to save the new sect*
exit to normal operation.
VX-SR OPERATING MANU ,
Advanced Operation
(AUTOMATIc RANGE TRANSPONDER SYSTEM
r Setup
e includes a CW
identifier, as discussed previously . Every ten minutes
",.
,peration, the radio can be
instructed to send "DE
(your callsign) K" if this
ed . The callsign field
may contain up to 8 characters .
rogram the CW Identifier :
/VII] key, then press the
[BAND(SET)AR]
key, to enter the Set mode .
DIAL
to select Menu #33 ("CW ID") .
AND(SET)AR]
key to enable changing of this Menu item .
DIAL
to set the CW ID function ON .
'91AND(SET)AR]
key once more to begin entry of the letters and
numbers
11sign .
DIAL
to select the first letter or number in your
callsign . When the correct
.
has been selected, press the
[BAND(SET)AR]
key to move on to the next
en
© as many times as necessary to complete
your callsign, pressing
ET)AR]
between each entry. Note that the "slant bar"
is among
le characters, should you be a
"portable" station .
the programming, before you exit, press
the
[FIW] key momentarily . You
'the CW Identification message as you have
programmed it .
have entered your entire callsign, press
the PTT key to save the settings and
al operation .
e
that the "DE" (- " " " )preceding your callsign is already
programmed,
only need to program your callsign, and the "DE" will
be appended at
time of transmission .
a
RATING MANUAL