Wiring Diagram - NEC VT440 Service Manual

Wiring Diagram

Monitor
VCR, DVD Player or LaserDisc Player
NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC
before turning on the power to the notebook PC. In most cases signal cannot be output from RGB output
unless the notebook PC is turned on after connecting with the projector.
NOTE:
* If the screen goes blank while using your remote control, it may be the result of the computer's screen-
saver or power management software.
* If you accidentally hit the POWER button on the remote control, wait 30 seconds and then press the
POWER button again to resume.
NOTE: If using video, S-video, or audio cables, the cables should be 3 m (9.8 feet) or shorter.
Speaker System
RGB INPUT AUDIO
IN
RGB OUTPUT
OUT
PC CONTROL S-VIDEO
VIDEO
To video, S-video, and audio
inputs on the projector.
Pin adapter for Macintosh (supplied)
OUT
IN
Signal cable (supplied)
To mini D-Sub 15-pin connector on the
projector. It is recommended that you
use a commercially available distribution
amplifier if connecting a signal cable
longer than the supplied cable.
Optional Component V cable
Document Camera
E–17
Macintosh or Compatibles
(Desktop type or notebook type)
IBM VGA or Compatibles
(Desktop type or notebook type)
DVD Player (with component output)