Specification - Grundig STR 400 AP Instruction Manual

Specification

Reception range:
Tuning system:
Frequency search:
Programmes:
Last station memory:
Sound IF:
Audio deemphasis:
Video deemphasis:
Stereo:
Remote control:
Display:
Timer:
Modulator:
LNC feed-in:
Connections:
Temperature range:
Mains voltage:
Power consumption:
Cabinet:
Weight:
German Federal Post Office
certification:
This device is interference suppressed in accordance with applicable european standards. It complies with safety directive VDE 0860
and thus with the international safety regulation IEC 65.
This device must only be operated with the cable supplied. This prevents disturbances from the mains and is an integral component of the
device. If a replacement is required, order only the mains cable set with the designation GWN 9.22 / Number 8290.991-316, from a custo-
mer service agency.
Subject to change without notice
Satellite signals of 10700 ... 13000 MHz, according to used LNC, (Ku-band)
C- and S-band frequencies: 2500 ... 4000 MHz
IF input of tuner: 910 ... 2050 MHz,
two signal inputs (A, B)
Frequency synthesizer with direct frequency entry.
Forward in 10 MHz steps.
Reverse in 3 MHz steps.
Single steps of 0.5 MHz; corresponds to finetuning.
ATS (Automatic Tuning System) for horizontal and vertical polarisation.
199 TV programmes, 199 radio programmes.
For TV and radio
Direct frequency entry of 5.00 ... 9.99 MHz, in 10 kHz steps.
With main carrier, Mono, MONO < >, selection possible between J 17 and 50 µsec.
FBAS
Baseband: non-clamped PAL-deemphasis 10 MHz
Baseband: non-clamped non-deemphasis 10 MHz
PANDA-Wegener-Licence
TP 720 SAT universal remote control handset.
1
VF display: 2 / -position 7-segment display, 8-position dot matrix, labels.
2
4-position Timer for switching on/off TV or radio programmes.
Frequency synthesizer: UHF CH 25 ... CH 60, CH 36 factory-preset.
14/18 V, max. 800 mA, LNC voltage with superimposed 22 kHz switching signal selectable.
If necessary, the LNC voltage can be switched off with switch
10-pole connector strip for controlling the external unit.
3 EURO-AV sockets (TV, decoder, and video recorder) with full-automatic
socket switching.
3 Cinch (phono) sockets (AF-Audio L and R, and remote control)
2 IEC coax sockets 75 Ω (terr. aerial input/output)
2 IEC coax sockets 75 Ω (SAT aerial input/output "A" and "B")
1socket 15 V/0.8 A =
Ambient temperature 0 ˚C ... + 40 ˚C, according to VDE 0860
220 ... 240 V~, 50/60 Hz
(control range of mains unit 190 ... 264 V)
25 W during operation (without motor run); 13 W in standby
(WxHxD) approx. 360x84 x 285 mm
approx. 2.1 kg
BZT KU 00705
3
30
wI
.