Remote Control Functions; Direct Programme Selection; Radio/Tv Switching; Programme Select Buttons - Grundig STR 400 AP Instruction Manual

Remote Control Functions

Direct Programme Selection

0
Use the numeric buttons
red programme (position).
If you enter more than one digit within approx. 3 seconds,
you can call up 2- or 3-digit programme positions.
If no second or third entry is made within this time, the entry
cursor jumps to the units position.
You can select 199 programme positions for TV and radio
each.
Further functions of the numeric buttons are explained in
chapter "Buttons on the Remote Control Handset".

Radio/TV Switching

0
Use the or ¢ button to switch between TV and radio
RADIO
mode.
In radio mode, the picture screen remains dark and an " R "
appears after the station name in the display. When swit-
ching, the display indicates for approx. 2 seconds " RADIO "
or " TV ".

Programme Select Buttons

]|
Step-by-step programme selection is effected with the
buttons. Holding down these buttons automatically
] |
selects the programme positions at high speed. Inactive pro-
gramme positions are skipped.

Buttons

x c
In the Timer menu (see chapter "Timer Menue"), you can
select one of the 4 Timer positions with the
After pressing the ¢ button, you can control the motor for
F
positioning the aerial by pressing the
If you press and hold down the
volume of your TV set with the
9
... to directly select the desi-
buttons.
x c
buttons.
x c
¢
TV
button, you can set the
SAT
buttons.
x c

Standby

b
b
With the button, the receiver is switched to standby. The
display indicates " ". LNC, switching- and AV voltages are
switched off.
When in standby, pressing one of the numeric buttons
0 9
... switches on the corresponding programme. When
using the buttons, the receiver switches to the last
] |
selected TV programme (Last Station Memory).
¢

Button

T V
When using a suited TV receiver, the
toggle between satellite and terrestrial reception.
Button
.
.
Pressing the button opens the Timer menu (see chapter
"Timer Menu").
A further pressure on the
O Button
Pressing the O button indicates for approx. 3 seconds the
satellite position, e.g., " 10 ° EAST ".
In addition, this button is used for a variety of other functions
(e.g., storing the Timer programme in memory, see chapter
"Timer Menu").

Switching the Remote Control Level

So that you can independently control two SAT receivers
being operated at a time (e.g., one for TV reception and the
other for video recording), it is possible to switch the remote
control level.
When switching the receiver on while holding down the
¢ P/F button on the receiver, the current level " REMOTE 1 "
respectively " REMOTE
seconds. At the factory, level 1 (Remote 1) has been preset.
When holding down the
switching on, the receiver will switch to the other level.
Through simultaneously pressing the
remote control handset and one of its other command but-
tons, you can switch to the second command level of the
remote control so that you can control a second receiver
independently of the first one.
26
¢
T V
button allows you to
.
button closes the Timer menu.
2 " is indicated for approx. 3
¢
P/F button a longer time when
8
( ) button on the
-