Operation Check - Sharp MX-2010U Installation Manual

6) Attach the MFP control PWB unit to the main unit.
1
7) Turn ON the main power switch and the operation panel power
switch.
8) Check to confirm that the machine is booted normally.
Check to confirm that the E7-03 error does not occur.
Wait until the display of "Wait for a while" disappears.
While "Wait for a while" is displayed, never turn OFF the
power.
D. Firmware version up
1) Use SIM22-5 to confirm that the version is displayed in the
firmware and the watermark.
2) Write the data backed up in the procedure C-2) into the SD
card.
Enter the SIM56-12 mode, and press [EXECUTE] key and
[YES] key.
When the backup operation is completed, "COMPLETE" is dis-
played. Check to confirm the display.
3) Use SIM49-1 to upgrade the firmware to the latest version.
4) Use SIM66-10 to clear the FAX and image send image mem-
ory. (Ensure consistency between the HDD data and the
image data memory.)
2
2
2
MX-3610N MX-HD10 (HARD DISK EXPANSION KIT) 6 – 3
E. Shield plate and left cabinet attachment
1) Attach the shield plate.
1
2) Attach the left cabinet.
1
4. User data restore
When the user data were backed up in the procedure 2, the user
data must be restored.
When a HDD option is installed to a machine which has been not
used, the procedure is not required.
1) Use SIM56-2 to restore the data which has been backed up in
the procedure 2-1).
Insert the USB memory into the USB connector in the machine
operation section. Enter
[EEPROM&SD IMPORT] and press [EXECUTE] key and
[YES] key.
When the backup operation is completed, "COMPLETE" is dis-
played. Check to confirm the display.
2) Use the device cloning function to restore the data backed up
in the procedure 2-2).
5.

Operation check

1) Check the machine operations.
Check to confirm that the copy operation is executed normally.
2
2
2
the SIM56-2 mode, select