Assemble Handle
1.
To make installation easier,
submerge handle grip into
warm soapy water. Remove
handle grip from soapy water
and slide onto handle.
2.
Insert the handle inside the
compressor saddle and line
up the two bolt holes on each
side.
3.
Install the four screws, two on
each side.
4.
Tighten securely.
Assemble Wheels
will have a tendency to tip.
1.
Attach wheels with shoulder bolts and nuts as shown. NOTE: Place the
bolts in the bottom hole of the wheel bracket.
Tighten securely. NOTE: The outfit will sit level if the wheels are properly
2.
installed.
down stairs or steps. The unit must be lifted, or pushed up a ramp.
Assemble Rubber Feet
1.
Attach rubber feet with the screws provided as shown in previous figure.
2.
Tighten securely.
ASSEMBLY
It will be necessary to brace or support one side of the
outfit when installing the wheels because the compressor
The wheels and handle do not provide adequate
clearance, stability or support for pulling the unit up and
9- ENG
Screw
Nut
Wheel
Shoulder Bolt
Rubber Feet
A08202