Toggle Vibrate Indicator
The MX9 vibration motor is activated when a scan is completed successfully (good scan vibration) or with a failure (scan key
released before good scan, timeout, or rejected because of Data Options configuration).
The vibrations can be detected under the handstrap or through the trigger handle.
Use the Speaker Volume / Vibrate Icon in the top right corner of the Today screen to toggle sound and/or vibration on or off.
Vibration can also be set using Start > Settings > System > Data Collection > Notification tab. Since the Data Collection
Wedge uses the operating system interface to sound beeps, if the volume/vibrate icon is set to anything other than On, Wedge
beeps do not sound. Wedge vibration is not affected by these settings.
2-7