Ip Preserve For Ipv6 - HP 8200zl Configuration Manual

ProCurve(config)# show snmpv3 targetaddress
snmpTargetAddrTable [rfc2573]
Target Name
------------------------- ---------------------- ---------------------------
1
2
PP.217
PP.218
An IPv6 address is
displayed on two lines.
Figure 5-9. "show snmpv3 targetaddress" Command Output with IPv6 Address
The show snmpv3 targetaddress command displays the configuration (including
the IPv4 or IPv6 address) of the SNMPv3 management stations to which
notification messages are sent.
IP Address
15.29.17.218
15.29.17.219
15.29.17.217
2620:0:260:211
:217:a4ff:feff:1f70

IP Preserve for IPv6

IPv6 supports the IP Preserve feature, which allows you to copy a configura-
tion file from a TFTP server to multiple switches without overwriting the IPv6
address and subnet mask on VLAN 1 (default VLAN) in each switch, and the
Gateway IPv6 address assigned to the switch.
To configure IP Preserve, enter the ip preserve statement at the end of the
configuration file that will be downloaded from a TFTP server. (Note that you
do not invoke IP Preserve by entering a command from the CLI).
IPv6 Management Features

IP Preserve for IPv6

Parameter
1
2
marker_p
marker_p
5-23