HP 8200zl Configuration Manual page 127

ProCurve(config)# show run
Running configuration:
; J8715A Configuration Editor; Created on release #K.13.01
hostname "ProCurve"
module 1 type J8702A
module 2 type J8705A
trunk A11-A12 Trk1 Trunk
ip default-gateway 2001:db8:0:7::5
snmp-server community "public" Unrestricted
vlan 1
name "DEFAULT_VLAN"
untagged A1-A10,A13-A24,B1-B24,Trk1
ip address 2001:db8::214:c2ff:fe4c:e480
exit
spanning-tree Trk1 priority 4
password manager
password operator
Figure 5-11. Configuration File with Dedicated IP Addressing After Startup with IP Preserve
Note that if a switch received its IPv6 address from a DHCP server, the "ip
address" field under "vlan 1" would display: dhcp-bootp.
For more information on how to use the IP Preserve feature, refer to the
"Configuring IP Addressing" chapter in the current Management and Config-
uration Guide for your ProCurve switch.
IPv6 Management Features
Because the switch's IPv6 address and
default gateway were statically configured
(not assigned by a DHCP server), when the
switch boots up with the IP Preserve startup
configuration file (see Figure 5-10), its current
IPv6 address, subnet mask, and default
gateway are not changed.
If a switch's current IP address was acquired
from a DHCP/Bootp server, the IP Preserve
statement is ignored and the IP addresses in
the downloaded configuration file are
implemented.
IP Preserve for IPv6
5-25