Mechanical Instructions - Philips L04HU Service Manual

4. Mechanical Instructions

Index of this chapter:
1. Set Disassembly
2. Service Position
3. Assy/Panel Removal
4. Set Re-assembly
Note: Figures below can deviate slightly from the actual
situation, due to different set executions.
4.1
Set Disassembly
Warning: Be sure to disconnect the AC power from the set
before opening it.
4.1.1
Rear Cover
1. Remove all fixation screws of the rear cover (Note: Do not
forget the screws that hold the rear connection panel).
2. Pull the rear cover backwards to remove it.
4.2
Service Position
Before placing the Mono Carrier in its service position, remove
the Front Interface assy/panel (see paragraph "Front Interface
Assy/Panel") and the Side AV assy/panel (see paragraph "Side
AV Assy/Panel").
2
3
Figure 4-1 Service position Mono Carrier
1
A
4
E_14480_048.eps
B
110204
Mechanical Instructions
1. Disconnect the degaussing coil [1].
2. Release the two fixation clamps (at the mid left and mid
right side of the bracket), and remove the bracket from the
bottom tray, by pulling it backwards [2].
3. Turn the chassis tray 90 degrees counter clockwise.
4. Move the panel bracket somewhat to the left and flip it 90
degrees [3], with the components towards the CRT.
5. Turn the panel bracket with the rear I/O toward the CRT.
6. Place the hook of the tray in the fixation hole of the cabinet
bottom [4] and secure it.
4.3
Assy/Panel Removal
4.3.1
Front Interface Assy/Panel
Figure 4-2 Front interface assy/panel removal
1. Remove the complete module from the bottom plate, by
pulling the two fixation clamps upward [1], while sliding the
module away from the CRT [2]. Note: these clamps are
difficult to access.
2. Release the two fixation clamps [3] at the side of the
bracket, and lift the panel out of the bracket (it hinges at
one side).
4.3.2
Side AV Assy/Panel
Figure 4-3 Side AV assy/panel removal
1. Remove the two fixation screws, and remove the complete
Side AV assembly.
2. Release the two fixation clamps, and lift the panel out of the
bracket.
L04HU AA 4.
1
1
2
3
3
E_14480_049.eps
E_14480_050.eps
170204
EN 7
110204