Philips L04HU Service Manual page 17

5.8.8
Audio Processing
No Sound
Picture Ok,
No Sound
Tuner IF Ok Not Ok
Ok
Check AUDOUTLSL &
AUDOUTLSR pin at Not Ok
Hercules
Ok
Check Audio
Not Ok
Amplifier
Figure 5-12 Fault finding tree "No sound"
No RF audio for QSS/Inter-Carrier stereo sets.
1. Check pin 99 and 100 for SIF signal (for QSS) or pin 104
and 105 for video with SIF (for Inter-Carrier)
2. If signal is not present, check for the QSS/FMI bit settings.
Check also the NVM data.
3. If signals are present and still no audio, check the audio
supply voltage +8V are present.
4. If still no audio signal at Hercules output, Hercules is faulty.
No AV audio.
1. Check troubleshooting methods in section "Source
Selection".
2. Check the output of the Hercules to see if there is signal
available. If no, check the normal operating condition and
also the NVM data.
3. If still no audio signal at Hercules output, Hercules is faulty.
Note: If there is audio signal at Hercules output and no audio
at loudspeaker, proceed to Audio Amplifier troubleshooting
methods.
5.8.9
Audio Amplifier
No RF as well as AV audio at the loudspeaker:
1. Check that the normal operation condition of the amplifier
is met.
2. If normal operation conditions are met, check the continuity
from Hercules output to input of the amplifier.
3. If continuity is there and still no audio, check speaker wire
connections. If still no audio, amplifier IC might be faulty
Service Modes, Error Codes, and Fault Finding
Check Tuner/IF
Check Hercules IC
Check Audio Check Power
Power Supply Supply
Ok
Check Audio
Replace Audio
Amplifier Circuit Not Ok
Amplifier
and loud speaker
Ok
Check NVM
E_14480_065.eps
170204
L04HU AA 5. EN 17