Packaging Configurations; Unpacking Process - HP StorageWorks XP10000 Disk Array Site Prep Manual

Packaging configurations
XP disk array cabinets are shipped in one of three standard packaging configurations:
• Environmental pack — consists of stretch wrap over corner protectors. No
special tools or procedures are required to unpack shipments in this form. This
packaging is used for most shipments within the USA and Canada that are direct
from the factory to the customer. HP uses special carriers with a dedicated fleet
of trucks and specially trained personnel.
• Full packaging — consists of a pallet, wooden loading ramp, inner packaging,
and outer corrugated carton assembly.
• Full packaging with wooden crate — consists of full packaging encased in a
wooden crate.

Unpacking process

If you need to unpack the equipment without HP supervision, follow the instructions
in this section.
1.
Following the steps "Removing packaging materials", unpack the equipment cartons
outside of the computer room to avoid debris and possible contamination of the
computer room environment.
2.
For software CDs, cables, and other installation hardware, leave the sealed cartons
or packages intact. HP representatives will unpack them when they install and
configure the disk array.
3.
As you unpack the cartons, match the delivered items to the packing list (invoice) for
each carton. Contact your HP SR immediately if any items are missing or are not
the ones you ordered.
4.
Move all equipment to the computer room before the installation date.
HP StorageWorks XP10000 Disk Array Site Prep Guide
61