Connecting To Jvc Av Compu Link Capable Components; Connecting To A Camcorder - JVC AV-32D501 User Manual

Connecting to JVC AV Compu Link Capable Components

JVC's AV Compu Link feature makes playing video tapes totally automatic. Simply insert a pre-recorded tape*
into your JVC-brand VCR and the VCR will automatically turn on and begin playback. At the same time, using
the AV Compu Link, the VCR sends a signal to the television telling it to turn on and switch to the proper video
input to watch a video tape.
• The AV Compu Link cable may be included with the JVC AV Compu Link accessory you wish to connect.
If it is not, contact an authorized JVC Service Center for part # EWP 805-012.
• AV Compu Link can only be used with JVC-brand products.
Illustration of AV-32D501
To Connect: Plug one end of the AV Compu Link cable into the AV Compu Link input on your VCR or other Compu
Link device. Plug the other end of the AV Compu Link cable into the AV Compu Link input at the rear of the television.

Connecting to a Camcorder

You may connect a camcorder to your television by using the front Input Jacks (Input 3) located under the front
panel door. To access, press lightly on the door to open it. You may also connect a game console or other
equipment using these jacks. Camcorders may also be connected to the television's rear input jacks.
1) Connect the yellow video cable out from the Camcorder's Video Output, in to the TV's Video Input jack.
2) Connect the white audio cable out from the Camcord e r' s Left Audio Output, in to the TV' s Left Audio Input Jack.
3) Connect the red audio cable out from the Camcord e r's Right Audio Output, in to the TV's Right Audio Input jack.
• If your Camcorder is a mono sound model it will have only one audio jack. Connect to the TV's Left Audio Jack.
NOTES (For AV Compu Link):
* In order for the VCR playback to begin automatically, the re c o rding tabs must be removed from the VHS tape. If the tab is in place,
automatic switching will occur when you push the VCR's P
• The AV Compu Link cable has a male 3.5 mm (mono) plug on each end.
• If your JVC-brand VCR has "A Code/B Code Remote Control Switching" (see your VCR's instruction book), using VCR A Code will
switch the TV to input 1. If you use Input 1 for video input from your cable box, use VCR B Code to select the TV Video Input 2.
• To connect a JVC HiFi receiver or amplifier for a completely automated home theater, see the HiFi's connection instructions for detailed
connection inform a t i o n .
• AV C O M P UL I N KE X is compatible with the following receivers: RX-664V, RX-665V, RX-668VBK, RX-774V, RX-778VBK, RX-884V,
RX-888VBK, RX-1024V, RX-1028VBK, and later receiver models.
Connections
b u t t o n .
L AY
9