Connecting To Jvc Av Compu Link - JVC PD-42V475 Service Manual

Quick Setup

Connecting to JVC AV Compu Link

JVC's AV CompuLink feature makes playing video tapes or DVDs totally automatic. Simply
insert a pre-recorded tape into your JVC brand VCR or DVD into your JVC DVD player and
the device will automatically turn on and begin playback. At the same time, using the
AV CompuLink, the VCR or DVD player sends a signal to the television telling it to turn on
and switch to the proper video input.
• The AV CompuLink cable may be included with the JVC AV CompuLink unit you
wish to connect. If it is not, contact JVC Parts Department at (800)-882-2345, or
www.jvcservice.com for part # EWP 805-012.
• AV CompuLink can only be used with JVC brand products.
AV CompuLink Cable
VIDEO
DIGITAL
HDMI
TV Underneath Panel
Notes:
• In order for the VCR playback to begin automatically, the recording tabs must be removed
from the VHS tape. If the tab is in place, automatic switching will occur when you push the
VCR's P button.
LAY
• If your JVC brand VCR has "A code/B code remote control switching" (see your VCR's
instruction book), using VCR A code will switch the TV to input 1.
• Refer to your DVD instruction book for detailed connection information.
• To connect a JVC HiFi receiver or amplifier for a completely automated home theater, see
the receiver connection instructions for detailed connection information.
• AV CompuLink is compatible with select AV CompuLink receivers.
16
AUDIO
DIGITAL
AV COMPULINK III
To Connect: Plug one end of the AV compu link cable
into the AV COMPU LINK INPUT on your VCR, DVD, or
other compu link device. Plug the other end of the AV
compu link cable into the AV COMPU LINK at the rear
of the TV.
Note:
• The AV compu link cable has a male 3.5 mm (mono)
plug on each end.
IN
OUT
Connections
VCR
V L R
IN
OUT
AV CompuLink