Flame Function; Remote Control Batteries - Rinnai ASPIRATION RHFE-750ETR Operation & Installation Manual

FLAME FUNCTION

The flame function is used to select a desired flame picture and overrides the
automatic mode. There are seven separate flame picture settings available.
While the heater is in operation press the Flame
this function. The heater will automatically default to the last used flame
picture setting. "Flame" and a series of seven short bars
of the seven flame picture settings) will be displayed to show that the flame
function is in operation.
Use the Up and Down
number of bars illuminated correspond to the flame picture setting selected.
To return to automatic mode press the Flame
Should the room temperature reach 40°C whilst the flame
function is activated the heater will switch off automatically.
NOTE This is a safety feature.

REMOTE CONTROL BATTERIES

Use 2 x 1.5V AAA batteries. NEVER mix old and new batteries.
Remove batteries if the remote control is not going to be used for a long
period. This will help avoid damage from leaking batteries.
To replace batteries simply unscrew the battery compartment cover located
on the back of the remote control anti-clockwise. When installing new batteries
ensure that the correct polarity is observed, the polarity is engraved into the
battery compartment. See the illustration on page 2.
Rinnai
BASIC HEATER OPERATION
buttons to select the desired flame picture. The
12
button once to activate
13
(one bar for each
31
button a second time.
13
8
Lock Override Auto Off Flame
31
AM
PM
Temperature Time
Timer 1 Set ON OFF
Timer 2 Set ON OFF
21
Lock Override Auto Off Flame
AM
PM
Temperature Time
20
Clock Set
Timer 1 Set ON OFF
Timer 2 Set ON OFF
STANDBY
11
Timer 1 14
ON
15
13 Flame Timer 2
Auto
Overide
17 16
Off
Time
19 Lock
18
Set
12
Operation Manual