License Plate Lamp - Chevrolet Equinox2011 Owner's Manual

To replace one of these lamps:
1. Open the liftgate. See Liftgate
(Manual) on page 2 8 or Liftgate
(Power) on page 2 8.
A. Screw
B. Screw Cover
2. Remove the two screw
covers (B) from the taillamp
assembly.
3. Remove the two screws (A)
securing the taillamp assembly.
4. Pull taillamp assembly out of
vehicle body.
5. Disconnect the lamp wiring
harness.
6. Turn the bulb socket
counterclockwise and pull it out.
7. Pull the bulb straight out of the
socket.
8. Install the new bulb.
9. Push the bulb socket in and turn
it clockwise.
10. Reverse steps 2 through 5 to
reinstall lamp assembly.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care

License Plate Lamp

To replace one of these bulbs:
1. Open the liftgate partway. See
Liftgate (Manual) on page 2 8 or
Liftgate (Power) on page 2 8 for
more information.
Passenger side shown, driver side
similar
2. Push the left end of the lamp
assembly towards the right.
3. Pull the lamp assembly down to
remove from liftgate.
10-35