Chevrolet Equinox2011 Owner's Manual page 363

2011 chevrolet equinox
Table of Contents

Advertisement

To tow the vehicle from the front
with all four wheels on the ground:
1. Position the vehicle that will be
towed and secure it to the
towing vehicle.
2. Turn the ignition key to ON/RUN.
3. Shift the transmission to
N (Neutral).
4. Turn the ignition key to
ACC/ACCESSORY.
5. Turn all accessories off.
6. To prevent the battery from
draining while the vehicle is
being towed, remove fuse 32,
the Discrete Logic Ignition
Switch fuse, from the instrument
panel fuse block and store it in a
safe location. See Instrument
Panel Fuse Block on
page 10 40.
Notice: If the vehicle is towed
without performing each of the
steps listed under Dinghy
Towing, the automatic
transmission could be damaged.
Be sure to follow all steps of the
dinghy towing procedure prior to
and after towing the vehicle.
Notice: If 105 km/h (65 mph) is
exceeded while towing the
vehicle, it could be damaged.
Never exceed 105 km/h (65 mph)
while towing the vehicle.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care
Once the destination has been
reached:
1. Set the parking brake.
2. Shift the transmission to
P (Park).
3. Turn the ignition key to
LOCK/OFF.
4. Install fuse 32, the Discrete
Logic Ignition Switch fuse. See
Instrument Panel Fuse Block on
page 10 40.
5. Start the engine and let it idle for
more than three minutes before
driving the vehicle.
Notice: Too much or too
little fluid can damage the
transmission. Be sure that the
transmission fluid is at the
proper level before towing with
all four wheels on the ground.
10-77

Advertisement

Table of Contents
loading

This manual is also suitable for:

Equinox 2011

Table of Contents