After Use Storage; Maintenance - Bosch Aquatak 150 Original Instructions Manual

F 016 L70 723.book Seite 5 Donnerstag, 29. September 2011 1:16 13
only Aquatak 150 X
L
The product is fitted with two detergent tanks. The
detergent adjustment knob 11 is used to switch the
suction between detergent tanks and increase/de-
crease detergent flow.
Recommended cleaning method
Step 1: Loosening dirt
Spray on detergent sparingly and allow to react for a
short time.
Step 2: Removing dirt
Spray off the loosened dirt with the high-pressure
spray.
Note: When cleaning a vertical surface spray off dirt/
detergent from the bottom and work in an upwards
direction. Rinse from the top and work down-
wards.
Chemicals dangerous to the environment must not
be allowed to enter the ground, ground water or
ponds, streams, etc.
For the use of cleaning agents, observe the instruc-
tions on the package and the prescribed concentra-
tion exactly.
For the cleaning of motor vehicles the local regula-
tions should be observed: Do not allow oil sprayed
off to enter into the ground water. Recycle raw ma-
terials instead of waste disposal.

Maintenance

Stop, remove plug from the power supply
and disconnect from water supply.
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as loose
fixings, and worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
If the pressure washer should happen to fail despite
the care taken in manufacture and testing, repair
should be carried out by an authorised service agent
for Bosch garden products.
For all correspondence and spare parts orders, al-
ways include the 10-digit part number (TYP) from
the nameplate of the machine!
Cleaning/inspecting the filter
S Expose the filter 18 in the machine water inlet
connection 13 by removing the inlet connector 16.
The filter 18 can be easily removed with long nose
pliers. Rinse and replace. If damaged replace.
17 • F 016 L70 723 • TMS • 13.09.11
Never use the pressure washer without the filter 18
or a damaged filter.
Using the pressure washer without/damaged fil-
ter 18 will invalidate the warranty.
Transport
To move the machine use the top handle and roll the
machine on the wheels.
To transport the unit up or down steps or over obsta-
cles, it must be lifted by the top handle.
If the unit is to be stored or transported horizontally
the detergent tank should be drained first.

After use storage

Clean the exterior of the machine thoroughly using a
soft brush or cloth. Do not use water, solvents or pol-
ishes. Remove all debris, especially from the venti-
lation slots.
Frost will damage a pressure washer that has not
been completely emptied of water. The machine
should be stored in a frost free room.
Do not place other objects on top of the machine.
Ensure cables are not trapped when storing. Do not
kink high pressure hose.
English - 5