Maintenance; After Use Storage - Bosch AQUATAK 110 Operating Instructions Manual

Advice using pressure washer
General
Ensure that the machine is on level ground.
Do not overreach with the high pressure hose or
move the pressure washer by pulling the hose, this
could cause the machine to become unstable and
fall over.
Do not kink or drive a motor vehicle over the high
pressure hose. Do not expose the high pressure
hose to sharp edges or corners.
Never use the roto nozzle to clean motor vehicles.
Operating with Detergents
Only use Bosch approved detergents. Unsuita-
ble detergents may damage the unit and the ob-
ject being cleaned.
AQUATAK 110
Attach the detergent-nozzle to the spray gun.
Fill the detergent bottle with suitable detergent and
screw the bottle back on the detergent-nozzle.
AQUATAK 110 PLUS/115 PLUS
Fill the detergent tank 9 with detergent, dilute as
H
recommend.
To spray detergent move vario-jet-fan power
G
lance to low pressure mode.
We recommend that you use detergent sparingly for
the sake of the environment. Observe the re-
commended dilution on the detergent label.
By offering you an individualised range of cleaning
and preserving agents, Bosch guarantees trouble-
free operation of the unit.
Recommended cleaning method
Step 1: Loosening dirt
Spray on detergent sparingly and allow to react for a
short time.
Step 2: Removing dirt
Spray off the loosened dirt with the high-pressure
spray.
Note: When cleaning a vertical surface spray off
dirt/detergent from the bottom and work in a up-
wards direction. Rinse from the top and work down-
wards.
1 • F016L70 xxx • 05.05 F016L70 350 • 05.10

Maintenance

Stop, remove plug from the power supply
and disconnect from water supply.
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as loose
fixings, and worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
If the pressure washer should happen to fail despite
the care taken in manufacture and testing, repair
should be carried out by an authorised service agent
for Bosch garden products.
For all correspondence and spare parts orders, al-
ways include the 10-digit part number from the
nameplate of the machine!
Cleaning/inspecting the strainer
Expose the strainer 14 in the machine water inlet
L
connection by removing the inlet connector 8.
The strainer 14 can be easily removed with long
nose pliers. Rinse and replace. If damaged replace.
Never use the pressure washer without the strainer
or a damaged strainer.
Transport
To move the machine use the top handle and roll the
machine on the wheels.
To transport the unit up or down steps or over obsta-
cles, it must be lifted by the top handle.
If the unit is is be stored or transported horizontally
the detergent tank should be drained first.

After use storage

Clean the exterior of the machine thoroughly using a
soft brush or cloth. Do not use water, solvents or pol-
ishes. Remove all debris, especially from the venti-
lation slots.
Frost will damage a pressure washer that has not
been completely emptied of water. The machine
should be stored in a frost free room.
Do not place other objects on top of the machine.

Ensure cables are not trapped when storing.
Do not kink high pressure hose.