Table of Contents
Advertisement
– inner grill with wool
Remove all carbon deposit in the muf-
fler.
Remove carbon deposits from the
spark arrester using a brush.
NOTE: Use a soft brush and be careful
to avoid damaging spark arrester.
Installation
For installation, reverse the removal
procedure, paying attention to the fol-
lowing details:
Check:
– wool and change if it deteriorate
– the spark arrester condition, it must
be free of breaks and holes. Replace
if necessary
Remove the old sealant joint and re-
place by a new one. Use ULTRA COO-
PER sealant (P/N 413 710 300).
V02C08Y
Be sure that wool is in place when in-
serting grill.
Align grill properly in bottom of muffler
shell.
Fuel System
Air Filter Cleaning/Draining
Periodically inspect air filter box drain
plug for water or deposits.
1
V02A0CY
1. Air filter box
2. Drain plug
3. Clamp
NOTE: If vehicle is used in dusty area,
inspect more frequently than specified
in maintenance chart.
If water/deposits are found, squeeze
and remove the clamps. Pull drain
tubes out.
CAUTION: Do not start engine when
water is found in the drain tubes.
When water/deposits are found, the air
filter must be inspected/dried/replaced
depending on its condition.
Remove air filter as explained below.
Air Filter Removal
CAUTION: Never remove or modify
any component in the air box. Always
use genuine parts or suitable equiva-
lent when replacing air filter and
foam. The engine carburetion is cali-
brated to operate specifically with
these components. Otherwise, en-
gine performance degradation or
damage can occur.
Remove seat.
3
2
65
Hide quick links:
Advertisement
Table of Contents
