Polaris TurboTurtle Owner's Manual page 4

C. Adjusting the Float Hose
1. With the pool filtration pump off, connect the
float hose to the pool wall by turning the quick
disconnect clockwise into the universal wall fit-
ting. Pull away from the pool wall to secure.
Universal Wall
Fitting (Installed)
uick uick
Disconnect Disconnect
2. Extend the float hose to the farthest point
in the pool.
3. Cut the float hose so it is four feet short of the
farthest point of the pool.
pprox.
Four Feet
If the float hose does not come within four feet
of the farthest point, you will need to add a float
hose extension kit (part #6-221-00) available at
a participating Polaris dealer.
4. Remove the hose connector from the portion
of excess hose that was just removed and
attach it to the new end of the float hose. See
the diagram at the top of the next column.
5. Attach the sweep hose and the filter bag to
the jet sweep assembly. When attaching the
filter bag, make sure its frame is completely
open.
6. Attach the float hose and the sweep hose to
the surface module. When attaching the
Removing the Connector
ollapse Here
Female
Hose
onnector
Insert
to Here
sweep hose, make sure the large ends of the
wheel cages are pointing toward the filter bag.
Float
urface
Hose
Module
Jet weep
Assembly
Filter
Bag
NOTE: The connectors twist independently of the
hose. When attaching them, twist only the connec-
tors so the hose does not get twisted.
7. Put the Polaris in the pool and turn on the pool
pump. Extend the float hose back to the
farthest point in the pool. The float hose is
Approx.
1' From the
Farthest
Point
4
1. Collapse hose with fingers.
2. Replace connector with only first
corrugation inside lip of connector.
3. Pop hose back into shape.
weep
Hose
Wheel
Cage
Hanger Kit
(Optional Accessory
Part #6-109-00)
Surface
Module
Float
Hose
Return Line