System Connections; Connecting To A Dolby Digital Decoder Or An Amplifier With Built-In Dts - JVC DR-MH20S Instructions Manual

SYSTEM CONNECTIONS

66
EN
Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.
Dolby Digital Decoder or
amplifier with built-in DTS
To DIGITAL AUDIO input
Optical cable
(not provided)
DIGITAL OUT (OPTICAL)
Note for connection:
Remove the protection cap from the optical
cable.
Coaxial cable
(not provided)
1
L-2
DIGITAL OUT (COAXIAL)
1
Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.
NOTES:
For Dolby Digital sound, set "DIGITAL AUDIO OUT" to "DOLBY
DIGITAL/PCM". ( pg. 67)
For DTS sound, set "DIGITAL AUDIO OUT" to "STREAM/PCM".
( pg. 67)
CAUTIONS:
This unit has a dynamic range of more than 110 dB with regards to its
Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to the
speakers may damage them.
Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely affect
the playback picture.