Table of Contents
Advertisement
Filename [MV5S_05Name.fm]
MV5S_00.book Page 15 Wednesday, August 31, 2005 4:55 PM
Connections
It's essential that your unit be properly connected.
ATTENTION:
Your TV must have a 21-pin AV input connector (SCART)
for the connection to the unit.
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
1
Make sure the package contains all of the
accessories listed in "SPECIFICATIONS" on
page 95.
2
Place the unit on a stable, horizontal surface.
3
Connect the unit to a TV depending on the TV and
cables you use.
(
pg. 15, "Composite Connection")
(
pg. 16, "Component Video Connection (DVD deck only)")
Aerial connector
Back of TV
21-pin SCART connector
21-pin SCART cable
(provided)
AC power cord
Back of unit
AC outlet
Page 15
RF cable
TV aerial cable
(provided)
ANTENNA IN
L-1 IN/OUT
ANTENNA OUT
GET OVER IT! – CONNECTIONS –
Composite Connection
1
Disconnect the TV aerial cable from the TV.
2
Connect the TV aerial cable to the [ANTENNA IN]
connector on the rear panel of the unit.
3
Connect the [ANTENNA OUT] connector on the rear
panel of the unit and the TV's aerial connector with
the provided RF cable.
4
Connect the [L-1 IN/OUT] connector on the rear
panel of the unit and the TV's 21-pin SCART
connector with a provided 21-pin SCART cable.
The [L-1 IN/OUT] connector accepts and delivers either a
composite signal (regular video signal), Y/C signal or
RGB signal.
Set your TV to the VIDEO (or AV), Y/C, or RGB mode
according to the type of your TV's SCART connector.
Select an appropriate option of "L-1 OUTPUT" as follows
(
pg. 44):
When your TV's SCART
connector accepts:
Composite video signals
Y/C signal (separated
luminance (brightness) and
chrominance (colour)
signals)
RGB signal
5
Plug the end of the AC power cord into an AC outlet.
"LOADING" blinks on the front display panel when the AC
plug of the power cord is connected into a AC outlet and
no operation will be done for approximately 50 seconds.
This is not a malfunction.
After connection is completed, perform "Auto Set Up" on
page 17.
Wednesday, 31 August 2005 16:55
Masterpage:Right0
15
EN
Set "L-1 OUTPUT" to:
"SCART VIDEO"
"SCART S-VIDEO"
"SCART RGB"
Advertisement
Table of Contents
