Manual Tv Station Presetting - JVC 2A73501A User Manual

Manual TV station presetting

ATS stores the broadcast automatically.
However if you do the ATS under
unfavorable receiving conditions,
some broadcasts happen to be not
finded by ATS. For these broadcasts,
you can store also by manual.
Note:
Occasionally, the auto search might catch
a weak signal and stop. If the TV station
signal is weak, you shouldn't store this
station.
In that case restart the auto search using
or .
20
Preparation:
• Turn ON the TV and set to the video input mode.
• Make sure TV/VCR/DVD switch has been slided to VCR/DVD. Then
press VCR to select the VCR mode. (The VCR indicator will light)
Example: Preset the SAT1 on program position 5.
1
Press SET UP MENU.
Press or
CHANNEL SETUP. Then press
OK.
2
Press or to select CH
TUNING. Then press OK.
3
DEC OFF will blink. Press OK.
DEC OFF does not blink any
more. SEARCH will appear.
Note:
If you wish to store the
PREMIERE manually,
decoder must
connected as on the lower of p.11.
During DEC OFF is blinking, press
DEC ON will blink now.
Press OK.
4
Press (rising frequency) or
(falling frequency) once. The
search starts. It stops at each
broadcast automatically ("
change to " 4 "). Press
repeatedly until the SAT1
appears. Only in case of receiving
of the weak broadcast (drifting
picture), search dose not stop. If
you want to stop, press
/ .
ATS (AUTO TUNING SYSTEM)
to select
TIMER REC SET
VCR EXTENSION
VCR SETUP
CHANNEL SETUP
SYSTEM SETUP
SELECT :
ENTER : OK
EXIT
CHANNEL SETUP
CH TUNING
CHANNEL MAPPING
SELECT :
ENTER : OK
EXIT
DEC OFF
the
SELECT :
OK
have been
.
"
or
DEC OFF
SEARCH :
EXIT
/ or
: MENU
: MENU
VPS CH 1
ARD
: OK EXIT : MENU
CH 1
/ F. TUNE :
: MENU