Table of Contents
Advertisement
If the timer program did not complete correctly, the error number appears on the timer pro-
gramming list.
Timer Programming
Date
Start
End
CH
*
JAN/01
12:57AM 1:57AM
CH8
2.
---
3.
---
Each error number means:
E1-22
Recording error other than
E37-39
below
E23-24
Unrecordable disc
E25-28
Copy prohibited program
E29
Disc protected
E30
Disc full
E31-32
Already 99 titles recorded
E33
Already 999 chapters recorded
E34
No space for Control information
E35
PCA full
Explanation on the front panel indicator during Timer Recording
(CLOCK) mark
Recording
Timer Recording (cont'd)
Speed
Error number will appear
E22
E36
Already finalized Video format
disc
E40
Some portion has not been
recorded because of program
overlapping. Recording did not
start at the start time.
E41
Power failed
E42
No disc when recording
Lights off
- An OTR is completed, and
there is no other timer
recordings in standby.
- The timer standby mode is
cancelled by pressing
[STANDBY/ON y y /I].
- [STANDBY/ON y y /I] is
pressed during timer stand-
by, and the component that
is not in timer standby
mode is turned on.
Note
• A program with the error
number is highlighted in gray
of the asterisked line in the
timer programming list.
• Once the timer programming
list with error indication is dis-
played, the program line(s)
with error will be cleared only
after the programs are can-
celed and reset to the timer
standby mode.
• The current recording pro-
gram will be highlighted in red.
Lights on
- The unit entered into the
timer standby mode.
- A Timer Recording or an
OTR has started.
- When this indicator is on,
you cannot use [SET UP].
Flashing
- All timer recordings are
completed.
- The DVD entered into the
timer standby mode when
no disc or an unrecordable
disc is in the unit.
- The disc runs out of the
space during Timer
Recording.
EN
35
Advertisement
Table of Contents
